A T-Ball Type Tee That Does Not Tip Over: MacGregor Batting Tee

By | Jan 10, 2011

There’s not much to say about something as mundane as a batting tee unless you have used some of the less expensive ones. You know, you put the ball on the tee and when your fourth-grader takes a swing, the tee falls over because its made of cheap plastic. This is no the case with […]

How To Cut Clean Holes In Plastic: Neiko 3-Piece Titanium Step Drill Bits Set

By | Jan 9, 2011

So I have a problem. I need to drill about 150 holes in 7 large plastic buckets for a project I am working on and I realize that every hole I drill using a conventional bit is leaving all this rough, chopped up plastic inside the bucket where I need to place soft, impressionable materials […]

© 2009 Edge of Normal. *Edge Of Normal: Where Small Business and Technology Meet